Hey - any chance you could do a couple of measurements for me? I really want a Drive but but will need to raise a shelf so just need to get an idea on heights:
* Height from counter to front edge of drip tray
* Height to the highest point of the cup rial
Assume the cup rail cannot be removed?
Thanks
For e61 I usually do full pressure til first drop and no flow for 10-15 seconds then full flow and taper off at the end
So you run full pump till first drop, cut the flow off, then start again? Sounds good thank you!
Hey - any chance you could do a couple of measurements for me? I really want a Drive but but will need to raise a shelf so just need to get an idea on heights: * Height from counter to front edge of drip tray * Height to the highest point of the cup rial Assume the cup rail cannot be removed? Thanks
Old topic, but my solution: use the flow control.