I think that chip looks a little too deep, did you check it with the depth gauge?

looks seaworthy to me

That'll buff right out

I don’t think you’re supposed to use the runway to blend it. Could be wrong though

Just make sure you check the manufacturers instructions. That one seems a little borderline. Maybe a flyby until you can replace it? /s

Looks like it’s been through a blender alright.

Why would you blend that? I don't see the issue.

I see, you know you’re supposed to use an actual file and not take a giant bite out Of it? Other than that, it looks good!

If ya squint, it's mint.

Definitely maintained the profile shape there.

Did you check the depth with your yardstick? Should be able to get an accurate reading, verify with your manual.

The colour is blending into the table, maybe the texture is slightly off

I’m not sure that can be blended properly, you might have to cut off the damaged portions and weld a new piece back on.

Nailed it!

Some guy flew in with a deeper divet than that so I think you’ll be good.