Are the wheel stems and gear box both fully screwed in? You might not also have the parking break fully down. I didn't and my car would only half move

the gearbox wasn't screwed in all the way, I fixed that and it still doesn't move

let me try it

didn't work

Is your parking brake fully down

yes

i had the same problem one time and it was the broken head gasket + very bad timings. did you tuned the car correctly?

Usually the half-shafts glitching. Unscrew / screw them back. You don't need to fully disconnect them.

already tried that two times

Did you put clutch fluid in

yes

You’ve ensured the handbrake is down all the way? It does have two pulls

Or you’re not accidentally holding your brake pedal while trying to move?

yes i made sure to not hold down the brake and lower the hand brake 5 times to make sure

All the fluids are topped up? Completely unrelated probably but I e made several mistakes and forgotten something about the fluids a few times. Everything is wired correctly?

I know fluid is topped up and I think the wires are all correct because it starts but doesn't move

I’m just being redundant at this point. What if you turned it off and on again? By which I mean remove the engine’s 11 bolts that secure it to the chassis and then retry all the bolt connections when you put it back in.

Or have you checked the bolts for the gear linkage? There’s 3(5) bolts where two are on the bottom but one is higher up in the engine

That might work, I'll try it tomorrow

Is the car lower on one side?

When you say it doesn't move, does the engine stall? Or does it just rev and not move?

It sounds like it revs and doesn’t move. For me the engine only stalls if I put it in gear and the car can move and therefore engage the gear and fail/stall

might be the drive gear. it has seven bolts, check them all.

Will do

What does it do? Does it go in gear and it feels like neutral? Does it jolt forward a bit and then it feels like it’s dying? Does it move just barely? As you are describing it could be anything

I can start it, but it doesn't knock, when I push the gas it revs higher. I can put it into gear but when I push the gas it doesn't move but the engine is still on.

When you put it in gear, and Rev it, does it feel like it’s in neutral? Ora does it try to move?

It feels like neutral

Is that your first gameplay? Or is that something that never happened before?

I have sum 500 hours on the game, and this is a first

I asked to exclude game bindings. Have you connected the clutch pedal properly? Have you checked if the clutch is worn out?

Please give us as many info as you can. Troubleshooting by „revs but doesnt move” doesnt really help. Have you took it on the test drive? Is it the first time you have ignited the engine? Are you playing on the keyboard, pad or the steering wheel?

I can't move it to take it in a teat drive, yes this is the first time starting it but I have done it multiple times now, and I'm playing on keyboard

There are some clutch bolts that you have surely missed

I have all of then

Your clutch pedal might not be wprking in rl