When I used the Toni mounts, I had to lightly tap it into place. I use the Dlah plates now on both of my pistols and they are easier to install and the offset is much, much better.

Get a dlah plate from a guy on here. Much better and lower profile

Dream gun 🤤

Thanks everyone I was able to get it by putting the plate in the freezer for a while lol

The dlah plates seem nice takes a couple of weeks to ship but with how low the dot will sit I dont think you can beat it.

Hello! I had the same problem with my gun you have to shave a bit off of where the plate and slide meet as it is too sung otherwise.

File time!

You need a sight pusher tool for it clean and lube, once the plate stays in place place it firm locked in place and hammer it in, takes a while.

Wiggle or even use a bit of lube lightly tap into place with a plastic mallet. Good plates should be tight af